Specifications

RoamAbout Mobility System Software Command Line Reference 11-49
set radio-profile auto-tune channel-interval
SetstheintervalatwhichRF Auto‐Tuningdecideswhethertochangethechannelsonradiosina
radioprofile.Attheendofeachinterval,MSSprocessestheresultsoftheRFscansperformed
duringthepreviousinterval,andchangesradiochannels ifneeded.
Syntax
set radio-profile name auto-tune channel-interval seconds
Parameters
Defaults
Thedefaultchannelintervalis3600seconds(onehour).
Mode
Enabled.
Usage
EnterasysNetworksrecommendsthatyouuseanintervalofatleast300seconds(5minutes).
RF Auto‐Tuningcanchangearadio’schannelbeforethechannelintervalexpiresinresponsetoRF
anomalies.Eveninthiscase,channelchangescannotoccurmorefrequentlythanthechannel
holddowninterval.
Ifyousetthe
intervalto0,RF Auto‐Tuningdoesnotreevaluatethechannelatregularintervals.
However,RF Auto‐TuningcanstillchangethechannelinresponsetoRFanomalies.
Example
Thefollowingcommandsetsthechannelintervalforradiosinradioprofilerp2to2700seconds
(45 minutes):
RBT-8100# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
Related Commands
• setradio‐profileauto‐tunechannel‐configonpage 11‐46
• setradio‐profileauto‐tunechannel‐holddownonpage 11‐48
• setradio‐profileauto‐tunechannel‐lockdownonpage 11‐50
• showradio‐profileonpage 11‐157
name Radioprofilename.
seconds NumberofsecondsRF Auto‐Tuningwaitsbeforechangingradiochannels
to
adjusttoRFchanges,ifneeded.Youcanspecifyfrom0to65535seconds.