Specifications

11-48 Access Point Commands
set radio-profile auto-tune channel-holddown
Setstheminimumnumberofsecondsaradioinaradioprofilemustremainatitscurrentchannel
assignmentbeforeRF Auto‐Tuningcanchangethechannel.Thechannelholddownprovides
additionalstabilitytothenetworkbypreventingtheradiofromchangingchannelstoorapidlyin
responsetospuriousRFanomaliessuch
asshort‐durationchannelinterference.
Syntax
set radio-profile name auto-tune channel-holddown holddown
Parameters
Defaults
ThedefaultRF Auto‐Tuningchannelholddownis900seconds.
Mode
Enabled.
Usage
ThechannelholddownappliesevenifRFanomaliesoccurthatnormallycauseanimmediate
channelchange.
Example
Thefollowingcommandchangesthechannelholddownforradiosinradioprofilerp2to600
seconds:
RBT-8100# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
Related Commands
• setradio‐profileauto‐tunechannel‐configonpage 11‐46
• setradio‐profileauto‐tunechannel‐lockdownonpage 11‐50
• setradio‐profileauto‐tunechannel‐intervalonpage 11‐49
• showradio‐profileonpage 11‐157
name Radioprofilename.
rate Minimumnumberofsecondsaradiomustremainonitscurrent
channel
settingbeforeRF Auto‐Tuningisallowedtochangethechannel.Youcan
specifyfrom0to65535seconds.