Specifications

11-46 Access Point Commands
set radio-profile auto-tune channel-config
Disablesorreenablesdynamicchanneltuning(RF Auto‐Tuning)fortheaccesspointradiosina
radioprofile.
Syntax
set radio-profile name auto-tune channel-config {enable | disable} [no-client]
Parameters
Defaults
Dynamicchannelassignmentisenabledbydefault.
Mode
Enabled.
Usage
IfyoudisableRF Auto‐Tuningforchannels,MSSdoesnotdynamicallysetthechannelswhen
radiosarefirstenabledandalsodoesnottunethechannelsduringoperation.
IfRF Auto‐Tuningforchannelsisenabled,MSSdoesnotallowyoutomanuallychangechannels.
EvenwhenRF Auto‐Tuningforchannelsisenabled,
MSSdoesnotchangethechannelonradios
thathaveactiveclientsessions,unlessyouusetheno‐clientoption.
RFAuto‐Tuningofchannelson802.11aradiosusesonlythebottomeightchannelsintheband(36,
40,44,48,52,56,60,and64).Touseahigherchannel
number,youmustdisableRFAuto‐Tuningof
channelsontheradioprofiletheradioisin,andusetheset{ap|dap}radiochannelcommandto
staticallyconfigurethechannel.
Example
Thefollowingcommanddisablesdynamicchanneltuningforradiosintherp2radioprofile:
RBT-8100# set radio-profile rp2 auto-tune channel-config disable
success: change accepted.
Related Commands
• setradio‐profileauto‐tunechannel‐holddownonpage 11‐48
• setradio‐profileauto‐tunechannel‐intervalonpage 11‐49
name Radioprofilename.
enable Configuresradiostodynamicallyselecttheirchannelswhentheradiosare
started.
disable Configuresradiostousetheirstaticallyassignedchannels,orthedefault
channelsifunassigned,when
theradiosarestarted.
no‐client Configuresradiostochangechannelsregardlessofclientstatus.Without
thisoption,aradiochangesthechannelonlyiftheradiodoesnothaveany
activeclientsonthatchannel.