Specifications

RoamAbout Mobility System Software Command Line Reference 11-45
set radio-profile active-scan
DisablesorreenablesactiveRFdetectionscanningontheaccesspointradiosmanagedbyaradio
profile.Whenactivescanningisenabled,accesspointradioslookforroguedevicesbysending
probeanyrequests(proberequestswithanullSSIDname),tosolicitproberesponsesfromother
accesspoints.
Passivescanning
isalwaysenabledandcannotbedisabled.Duringpassivescanning,radioslook
forroguesbylisteningforbeaconsandproberesponses.
Syntax
set radio-profile name active-scan {enable | disable}
Parameters
Defaults
Activescanningisenabledbydefault.
Mode
Enabled.
Usage
YoucanenterthiscommandonanyRoamAboutswitchintheMobilityDomain.Thecommand
takeseffectonlyonthatswitch.
Example
Thefollowingcommanddisablesactivescaninradioprofileradprof3:
RBT-8100# set radio-profile radprof3 active-scan disable
success: change accepted.
Related Commands
showradio‐profileonpage 11‐157
name Radioprofilename.
enable Configuresradiostoactivelyscanforrogues.
disable Configuresradiostoscanonlypassivelyforroguesbylisteningforbeacons
andproberesponses.