Specifications

11-40 Access Point Commands
set {ap | dap} radio tx-power
Setsanaccesspointradio’stransmitpower.
Syntax
set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level
Parameters
Defaults
Thedefaulttransmitpoweronallaccesspointradiotypesisthehighestsettingallowedforthe
countryofoperationorhighestsettingsupportedonthehardware,whicheverislower.
Mode
Enabled.
Usage
Youalsocanconfigurearadio’schannelonthesamecommandline.Usethechanneloption.
Thiscommandisnotvalidifdynamicpowertuning(RF Auto‐Tuning)isenabled.
Example
Thefollowingcommandconfiguresthetransmitpoweronthe802.11aradioontheaccesspoint
connectedtoport5:
RBT-8100# set ap 5 radio 1 tx-power 10
success: change accepted.
Thefollowingcommandconfiguresthechannelandtransmitpoweronthe802.11b/gradioonthe
accesspointconnectedtoport 11:
RBT-8100# set ap 11 radio 1 channel 1 tx-power 10
success: change accepted.
apport‐list Listofportsconnectedtothe accesspointsonwhichtosetthetransmit
power.
dapdap‐num NumberofaDistributedaccesspointonwhichtosetthetransmitpower.
radio1 Radio1oftheaccesspoint.
radio2 Radio2oftheaccesspoint.(Thisoptiondoesnot
applytosingle‐radio
models.)
tx‐powerpower‐
level
Numberofdecibelsinrelationto1 milliwatt(dBm).Thevalidvalues
dependonthecountryofoperation.
Note: The maximum transmit power you can configure on any Enterasys Networks
radio is the maximum allowed for the country in which you plan to operate the radio
or one of the following values if that value is less than the country maximum: on an
802.11a radio, 11 dBm for channel numbers less than or equal to 64, or 10 dBm for
channel numbers greater than 64; on an 802.11b/g radio, 16 dBm for all valid
channel numbers for 802.11b, or 14 dBm for all valid channel numbers for 802.11g.