Specifications

11-38 Access Point Commands
set {ap | dap} radio mode
Enablesordisablesaradioonanaccesspoint.
Syntax
set {ap port-list | dap {dap-num | auto}} radio {1 | 2} mode {enable | disable}
Parameters
Defaults
Accesspointradiosaredisabledbydefault.
Mode
Enabled.
Usage
Toenableordisableoneormoreradiostowhichaprofileisassigned,usethe
setapradioradio‐profilecommand.Toenableordisableallradiosthatuseaspecificradio
profile,usethesetradio‐profilecommand.
Example
Thefollowingcommandenablesradio1ontheaccesspointsconnectedtoports1through5:
RBT-8100# set ap 1-5 radio 1 mode enable
success: change accepted.
Thefollowingcommandenablesradio2onports1through3:
RBT-8100# set ap 1-3 radio 2 mode enable
success: change accepted.
Related Commands
• clear{ap|dap}radioonpage 11‐5
• set{ap|dap}radioradio‐profile onpage 11‐39
• setradio‐profilemodeonpage 11‐63
• show{ap|dap}configonpage 11‐128
apport‐list Listofportsconnectedtothe accesspoint(s)onwhichtoturnaradioon
or
off.
dapdap‐num NumberofaDistributedaccesspointonwhichtoturnaradioonoroff.
dapauto Setstheradiomodeforaccesspointsmanagedbytheaccesspoint
configurationprofile.(Seesetdapautoonpage 11‐13.)
radio1 Radio1oftheaccesspoint.
radio2 Radio2
oftheaccesspoint.(Thisoptiondoesnotapplytosingle‐radio
models.)
modeenable Enablesaradio.
modedisable Disablesaradio.