Specifications

11-36 Access Point Commands
set {ap | dap} radio auto-tune min-client-rate
Setstheminimumrateatwhicharadioisallowedtotransmittraffictoclients.Theradio
automaticallyincreasesitstransmitpowerwhennecessarytomaintainatleasttheminimumrate
withanassociatedclient.
Syntax
set {ap port-list | dap {dap-num | auto}} radio {1 | 2} auto-tune min-client-
rate rate
Parameters
Defaults
Thedefaultminimumdatatransmitratedependsontheradiotype:
•Thedefaultminimumdataratefor802.11b/gand802.11bradiosis5.5 Mbps.
•Thedefaultminimumdataratefor802.11aradiosis24 Mbps.
Mode
Enabled.
Usage
Ifthedataratefortrafficsentbyaradiotoanassociatedclientfallsbelow thedefaultminimum 
rate,theradioincreases power,in1dBmincrements,untilallclientsareatorabovetheminimum
rate.
Afterallclientsareatorabovetheminimumdatatransmitrate,theradio
reducespowerby
1dBm.Aslongastheradiocontinuestotransmitattheminimumdatarateorhigherforall
clients,theradiocontinuesreducingpowerin1 dBmincrementsuntilitreturnstoitsnormal
powerlevel.
apport‐list Listofportsconnectedtotheaccesspointsonwhich
tosettheminimum
datarate.
dapdap‐num NumberofaDistributedaccesspointonwhichtosettheminimumdata
rate.
dapauto Sets theradiomodeforaccesspointsmanagedbytheaccesspoint
configurationprofile.(Seesetdapautoonpage 11‐13.)
radio1 Radio1oftheaccesspoint.
radio2 Radio2oftheaccesspoint.(Thisoptiondoesnotapplytosingle‐radio
models.)
rate Minimumdatarate,inmegabitspersecond(Mbps).Thevalidvalues
dependontheradiotype:
•For802.11gradios—54,48,36,24,18,12,11,9,6,5.5,2,
or1
•For802.11bradios—11,5.5,2,or1
•For802.11aradios—54,48 ,36,24,18,12,9,or6