Specifications

RoamAbout Mobility System Software Command Line Reference 11-35
set {ap | dap} radio channel
Setsanaccesspointradio’schannel.
Syntax
set {ap port-list | dap dap-num} radio {1 | 2} channel channel-number
Parameters
Defaults
Thedefaultchanneldependsontheradiotype:
•Thedefaultchannelnumberfor802.11b/gis6.
•Thedefaultchannelnumberfor802.11aisthelowestvalidchannelnumberforthecountryof
operation.
Mode
Enabled.
Usage
Youcanconfigurearadio’stransmitpoweronthesamecommandline.Usethetx‐poweroption.
Thiscommandisnotvalidifdynamicchanneltuning(RF Auto‐Tuning)isenabled.
Example
Thefollowingcommandconfiguresthechannelonthe802.11aradioontheaccesspointconnected
toport5:
RBT-8100# set ap 5 radio 1 channel 36
success: change accepted.
Thefollowingcommandconfiguresthechannelandtransmitpoweronthe802.11b/gradioonthe
accesspointconnectedtoport 11:
RBT-8100# set ap 11 radio 1 channel 1 tx-power 10
success: change accepted.
Related Commands
• set{ap|dap}radiotx‐poweronpage 11‐40
• show{ap|dap}configonpage 11‐128
apport‐list Listofportsconnectedtothe accesspointsonwhichtosetthechannel.
dapdap‐num NumberofaDistributedaccesspointonwhichtosetthechannel.
radio1 Radio
1oftheaccesspoint.
radio2 Radio2oftheaccesspoint.(Thisoptiondoesnotapplytosingle‐radio
models.)
channelchannel‐
number
Channelnumber.Thevalidchannelnumbersdependonthecountryof
operation.