Specifications

11-32 Access Point Commands
set {ap | dap} radio antennatype
Setsthemodelnumberforanexternalantenna.
Syntax
set {ap port-list | dap dap-num} radio {1 | 2} antennatype
{ANT1060 | ANT1120 | ANT1180 | ANT5060 | ANT5120 | ANT5180}
Parameters
TheCLIantennaselectionsusedfortheRBT‐1602,andtheircorrespondingEnterasyspartnumber
arelistedinTable 11‐3.
Defaults
Allradiosusetheinternalantennabydefault,iftheAPmodelhasaninternalantenna.
Mode
Enabled.
Example
Thefollowingcommandconfiguresthe802.11b/gradioonDistributedAP 1touseantennamodel
ANT1060:
RBT-8100# set dap 1 radio 1 antennatype ANTxxx
apport‐list Listofportsconnectedtothe accesspointsonwhichtosetthe
channel.
dapdap‐num NumberofaDistributedAPonwhichtosetthechannel.
radio1 Radio1oftheAP.
radio2 Radio2oftheAP.
antennatype •Specifiestheantennamodelnumber.
• internal—Usestheinternalantennainstead.
Table 11-3 CLI Antenna Selections
CLI Antenna Selection Enterasys Antenna Part Number
ANT1060 RBTES-BG-S1060
ANT1120 RBTES-BG-S07120
ANT1180 RBTES-BG-S06180
ANT5060 RBTES-AW-S1460
ANT5120 RBTES-AW-S12120
ANT5180 RBTES-AW-S10180