Specifications

11-28 Access Point Commands
set {ap | dap} group
Configuresanamedgroupofaccesspoints.MSSautomaticallyloadbalancessessionsamongthe
accesspointsinagroup.Tobalancethesessions,MSSrejectsanassociationrequestforanaccess
point’sradioifthatradiohasatleastfourmoreactivesessionsthantheradioofthesametype
with
theleastnumberofactivesessionswithinthegroup.
Syntax
set {ap port-list | dap {dap-num | auto}} group name
Parameters
Defaults
Accesspointsarenotgroupedbydefault.
Mode
Enabled.
Usage
YoucanassignanysubsetoralloftheaccesspointsconnectedtoaRoamAboutswitchtoagroup
onthatswitch.AllaccesspointsinagroupmustbeconnectedtothesameRoamAboutswitch.
Ifyouusethenamenone,spelledinanycombinationofcapitalorlowercaseletters,
thespecified
accesspointisclearedfromallaccesspointgroups.
Example
Thefollowingcommandconfiguresanaccesspointgroupnamedloadbalance1thatcontainsthe
accesspointsonports1,4,and7:
RBT-8100# set ap 1,4,7 group loadbalance1
success: change accepted.
Thefollowingcommandremovestheaccesspointonport4fromallaccesspointgroups:
RBT-8100# set ap 4 group none
success: change accepted.
Related Commands
• show{ap|dap}configonpage 11‐128
• show{ap|dap}grouponpage 11‐139
apport‐list Listofaccess pointaccessportstoaddtothegroup.
dapdap‐num NumberofaDistributedaccesspointtoaddtothegroup.
dapauto Configuresanaccesspointgroupforthe
accesspointconfigurationprofile.
(Refertosetdapautoonpage 11‐13.)
name Accesspointgroupnameofupto16alphanumericcharacters,withno
spaces.