Specifications

11-26 Access Point Commands
set dap fingerprint
VerifiesanAP’sfingerprintonaRoamAboutswitch.IfAP‐RoamAboutSwitchsecurityisrequired
byaRoamAboutswitch,anAPcanestablishamanagementsessionwiththeswitchonlyifyou
haveverifiedtheAP’sidentitybyverifyingitsfingerprintonthe switch.
Syntax
set dap num fingerprint hex
Parameters
Defaults
None.
Mode
Enabled.
Usage
APsareconfiguredwithanencryptionkeypairatthefactory.Thefingerprintforthepublickeyis
displayedonalabelonthebackoftheaccesspoint,inthefollowingformat:
RSA
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
IfanAPisalreadyinstalledandoperating,youcanusetheshowdapstatuscommandtodisplay
thefingerprint.Theshowdapconfigcommand listsanAP’sfingerprintonlyifthefingerprinthas
beenverifiedinMSS.Ifthefingerprinthasnotbeenverified,thefingerprintinformationinthe
command
outputisblank.
Example
ThefollowingexampleverifiesthefingerprintforDistributedAP8:
RBT-8100# set dap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
Related Commands
• setdapsecurityonpage 11‐42
• show{ap|dap}configonpage 11‐128
• show{ap|dap}statusonpage 11 ‐140
Note: The AP3000 does not require a fingerprint.
dapdap‐num NumberoftheDistributedAPwhosefingerprintyouareverifying.
hex The16‐digithexadecimalnumberofthefingerprint.Useacolonbetween
eachdigit.Makesurethefingerprintyouentermatches thefingerprintused
bytheaccesspoint.