Specifications

11-24 Access Point Commands
set dap boot-vlan
Specifies802.1QVLANtagginginformationforaDistributedAP.
Syntax
set dap dap-num boot-vlan vlan-tag tag-value [mode {enable | disable}]
set dap dap-num boot-vlan mode {enable | disable}
Parameters
Defaults
None.
Mode
Enabled.
Usage
Whenthiscommandisconfigured,allEthernetframesemittedfromtheDistributedAPare
formattedwithan802.1QtagwithaspecifiedVLANnumber.Framessenttothe DistributedAP
thatarenottaggedwiththisvalueareignored.
Example
ThefollowingcommandconfiguresDistributedAP1touseVLANtag100:
RBT-8100# set dap 1 boot-vlan vlan-tag 100 mode enable
success: change accepted.
Related Commands
• cleardapboot‐configurationonpage 11‐7
• setdapboot‐iponpage 11‐20
• setdapboot‐switchonpage 11‐22
• showdapboot‐configurationonpage 11‐149
dapdap‐num NumberoftheDistributedAPforwhichyouarespecifying
VLANinformation.
vlan‐tagtag‐value TheVLANtagvalue.You
canspecifyanumberfrom1–4095.
mode{enable|disable}EnablesordisablesuseofthespecifiedVLANtagonthe
DistributedAP.