Specifications

RoamAbout Mobility System Software Command Line Reference 11-19
set {ap | dap} blink
EnablesordisablesLEDblinkmodeonanaccesspointtomakeiteasytoidentify.Whenblink
modeisenabledonAP‐xxxmodels,thehealthandradioLEDsalternatelyblinkgreenandamber.
set {ap port-list | dap {dap-num | auto}}blink {enable | disable}
Parameters
Defaults
LEDblinkmodeisdisabledbydefault.
Mode
Enabled.
Usage
ChangingtheLEDblinkmodedoesnotalteroperationoftheaccesspoint.Only thebehaviorof
theLEDsisaffected.
Example
ThefollowingcommandenablesLEDblinkmodeontheaccesspointsconnectedtoports3and4:
RBT-8100# set ap 3-4 blink enable
success: change accepted.
apport‐list Listofportsconnectedtothe accesspointsonwhichtoturnblinkmodeon
oroff.
dapdap‐num NumberofaDistributedaccesspointonwhichtoturnblinkmodeonoroff.
dapauto Configuresblinkmodefortheaccesspointconfigurationprofile.(Seeset
dapauto
onpage 11‐13.)
enable Enablesblinkmode.
disable Disablesblinkmode.