Specifications
RoamAbout Mobility System Software Command Line Reference 11-13
set dap auto
Createsaprofileforautomaticconf igurationofDistributedaccesspoints.
Syntax
set dap auto
Defaults
None.
Mode
Enabled.
Usage
Table 11‐2liststheconfigurableprofileparametersandtheirdefaults.Theonlyparameterthat
requiresconfigurationistheprofilemode.Theprofileisdisabledbydefault.Tousetheprofileto
configureDistributedaccesspoints,youmustenabletheprofileusingthesetdapautomode
enablecommand.
Theprofileuses
thedefaultradioprofilebydefault.Youcanchangetheprofileusingthesetdap
autoradioradio‐profilecommand.Youcanusesetdapautocommandstochangesettingsforthe
parameterslistedinTable 11‐2.(Thecommandsarelistedinthe“RelatedCommands”section.)
Table 11-2 Configurable Profile Parameters for Distributed Access Points
Parameter Default Value
AP Parameters
bias high
blink
(Not shown in show dap config output)
disable
force-image-download disable (NO)
group (load balancing group) none
mode disabled
persistent none
Radio Parameters
radio num auto-tune max-power default
radio num mode enabled
radio num radio-profile default
radiotype 11g
(or 11b for country codes where 802.11g is not
allowed)