Specifications

11-8 Access Point Commands
clear radio-profile
Removesaradioprofileorresetsoneoftheprofile’sparameterstoitsdefaultvalue.
Syntax
clear radio-profile name [parameter]
Parameters
Defaults
Ifyouresetanindividualparameter,theparameterisreturnedtothedefaultvaluelistedin
Table 11‐4onpage 11‐63.
Mode
Enabled.
Usage
Ifyouspecifyaparameter,thesettingfortheparameterisresettoitsdefaultvalue.Thesettingsof 
theotherparametersareunchangedandtheradioprofileremainsintheconfiguration.Ifyoudo
notspecifyaparameter,theentireradioprofileisdeletedfromthe configuration.Allradiosthat

usethisprofilemustbedisabledbeforeyoucandelete theprofile.
Examples
Thefollowingcommandsdisabletheradiosthatareusingradioprofilerp1andresetthe
beaconed‐intervalparametertoitsdefaultvalue:
RBT-8100# set radio-profile rp1 mode disable
RBT-8100# clear radio-profile rp1 beacon-interval
success: change accepted.
name Radioprofilename.
parameter Radioprofileparameter:
• beacon‐interval
•dtim‐interval
• countermeasures
• frag‐th reshold
• max‐rx‐lifetime
• max‐tx‐lifetime
• preamble‐length
• rts‐threshold
• service‐profile
(Forinformationabouttheseparameters,seethesetradio‐profile
commandsthatusethem.)