Specifications

RoamAbout Mobility System Software Command Line Reference 11-1

Access Point Commands

Useaccesspointcommandstoconfigureandmanageaccesspoints.Besuretodothefollowing

beforeusingthecommands:

•Definethecountry‐specificIEEE802.11regulationsontheRoamAboutswitch.(Refertoset

systemcountrycodeonpage 3‐16.)

•InstalltheaccesspointandconnectittoaportontheRoamAbout

switch.(Refertothe

RoamAboutWirelessSwitchInstallationGuidespecifictoyourwirelessswitch.)

• ConfigureanaccesspointaccessportforaDistributedaccesspoint.

Thischapterpresentsaccesspointcommandsalphabetically.Usethefollowingtabletolocate

commandsinthischapter.

Caution: Changing the system country code after access point configuration disables access

points and deletes their configuration. If you change the country code on a RoamAbout switch, you

must reconfigure all access points.

For information about... Refer to page...

clear {ap | dap} radio 11-5

clear dap boot-configuration 11-7

clear radio-profile 11-8

clear service-profile 11-10

reset {ap | dap} 11-12

set dap auto 11-13

set dap auto mode 11-15

set dap auto persistent 11-16

set dap auto radiotype 11-17

set {ap | dap} bias 11-18

set {ap | dap} blink 11-19

set dap boot-ip 11-20

set dap boot-switch 11-22

set dap boot-vlan 11-24

set dap fingerprint 11-26

set {ap | dap} force-image-download 11-27