Specifications

8-46 AAA Commands
mobility-profile
(network access
mode only)
Mobility Profile attribute for the
user. (For more information, see
set mobility-profile on page 8-52.)
Note: Mobility-Profile is an
Enterasys Networks vendor-
specific attribute (VSA). The vendor
ID is 14525, and the vendor type is
2.
Name of an existing Mobility Profile, which can
be up to 32 alphanumeric characters, with no
tabs or spaces.
Note: If the Mobility Profile feature is enabled,
and a user is assigned the name of a Mobility
Profile that does not exist on the RoamAbout
switch, the user is denied access.
service-type Type of access the user is
requesting.
One of the following numbers:
• 2—Framed; for network user access
• 6—Administrative; for administrative access to
the RoamAbout switch, with authorization to
access the enabled (configuration) mode. The
user must enter the enable command and the
correct enable password to access the
enabled mode.
• 7—NAS-Prompt; for administrative access to
the nonenabled mode only. In this mode, the
user can still enter the enable command and
the correct enable password to access the
enabled mode.
For administrative sessions, the RoamAbout
switch always sends 6 (Administrative).
The RADIUS server can reply with one of the
values listed above.
If the service-type is not set on the RADIUS
server, administrative users receive NAS-Prompt
access, and network users receive Framed
access.
session-timeout
(network access
mode only)
Maximum number of seconds for
the user’s session.
Number between 0 and 4,294,967,296 seconds
(approximately 136.2 years).
Note: If the global reauthentication timeout (set
by the set dot1x reauth-period command) is
shorter than the session-timeout, MSS uses the
global timeout instead.
ssid
(network access
mode only)
SSID the user is allowed to access
after authentication.
Name of the SSID you want the user to use. The
SSID must be configured in a service profile, and
the service profile must be used by a radio profile
assigned to Enterasys Networks radios in the
Mobility Domain.
Table 8-1 Authentication Attributes for Local Users (continued)
Attribute Description Valid Value(s)