Specifications

RoamAbout Mobility System Software Command Line Reference 7-85
show ntp
DisplaysNTPclientinformation.
Syntax
show ntp
Parameters
None.
Defaults
None.
Mode
All.
Example
TodisplayNTPinformationforaRoamAboutswitch,typethefollowingcommand:
RBT-8100> show ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
Table 7‐11describesthefieldsinthisdisplay.
Table 7-11 Output for show ntp
Output What it displays...
NTP client State of the NTP client. The state can be one of the following:
• Enabled
•Disabled
Current update-interval Number of seconds between queries sent by the RoamAbout switch to the
NTP servers for updates.
Current time System time that was current on the RoamAbout switch when you pressed
Enter after typing the show ntp command.
Timezone Time zone configured on the switch. MSS offsets the time reported by the
NTP server based on the time zone.
Note: This field is displayed only if you change the time zone.