Specifications
RoamAbout Mobility System Software Command Line Reference 7-83
Related Commands
• cleariprouteonpage 7‐8
• setinterfaceonpage 7‐24
• setiprouteonpage 7‐34
• showinterfaceonpage 7‐75
• showvlanconfigonpage 5‐24
Table 7-9 Output for show ip route
Output What it displays...
Destination/Mask IP address and subnet mask of the route destination.
The 244.0.0.0 route is automatically added by MSS and supports the IGMP
snooping feature.
Proto Protocol that added the route to the IP route table. The protocol can be one
of the following:
• IP—MSS added the route.
• Static—An administrator added the route.
Metric Cost for using the route.
NH-Type Next-hop type:
• Local—Route is for a local interface. MSS adds the route when you
configure an IP address on the RoamAbout switch.
• Direct—Route is for a locally attached subnet. MSS adds the route when
you add an interface in the same subnet to the RoamAbout switch.
• Router—Route is for a remote destination. A RoamAbout switch forwards
traffic for the destination to the default router (gateway).
Gateway Next-hop router for reaching the route destination.
Note: This field applies only to static routes.
VLAN:Interface Destination VLAN, protocol type, and IP address of the route. Because direct
routes are for local interfaces, a destination IP address is not listed.
The destination for the IP multicast route is MULTICAST.
For static routes, the value Down means the RoamAbout switch does not
have an interface to the destination’s next-hop router. To provide an
interface, configure an IP interface that is in the same IP subnet as the next-
hop router. The IP interface must be on a VLAN containing the port that is
attached to the default router.