Specifications

7-80 IP Services Commands
show ip https
Displaysinformationaboutthe HTTPSmanagementport.
Syntax
show ip https
Parameters
None.
Defaults
None.
Mode
All.
Example
ThefollowingcommandshowsthestatusandportnumberfortheHTTPSmanagementinterface
totheRoamAboutswitch:
RBT-8100> show ip https
HTTPS is enabled
HTTPS is set to use port 443
Last 10 Connections:
IP Address Last Connected Time Ago (s)
------------ ----------------------- ------------
10.10.10.56 2003/05/09 15:51:26 pst 349
Table 7‐8describesthefieldsinthisdisplay.
Table 7-8 Output for show ip https
Output What it displays...
HTTPS is enabled/disabled State of the HTTPS server:
• Enabled
•Disabled
HTTPS is set to use port TCP port number on which the RoamAbout switch listens for HTTPS
connections.
Last 10 connections List of the last 10 devices to establish connections to the RoamAbout
switch’s HTTPS server.
IP Address IP address of the device that established the connection.
Note: If a browser connects to a RoamAbout switch from behind a proxy,
then only the proxy IP address is shown. If multiple browsers connect using
the same proxy, the proxy address appears only once in the output.
Last Connected Time when the device established the HTTPS connection to the switch.