Specifications

RoamAbout Mobility System Software Command Line Reference 7-65
set system ip-address
ConfiguresthesystemIPaddress.ThesystemIPaddressdeterminestheinterfaceorsourceIP
addressMSSusesforsystemtasks,includingthefollowing:
• Mobilitydomainoperations
•DefaultsourceIPaddressusedinunsolicitedcomm unicationssuchasAAAaccounting
reportsandSNMPtraps
Syntax
set system ip-address ip-addr
Parameters
Defaults
None.
Mode
Enabled.
Usage
YoumustuseanaddressthatisconfiguredononeoftheRoamAboutswitch’sVLANs.
TodisplaythesystemIPaddress,usetheshowsystemcommand.
Example
ThefollowingcommandsconfigureanIPinterfaceonVLANtaupeandconfiguretheinterfaceto
bethesystemIPaddress:
RBT-8100# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
RBT-8100# set system ip-address 10.10.20.20
success: change accepted.
Related Commands
• clearsystemip‐addressonpage 7‐18
• setinterfaceonpage 7‐24
• showsystemonpage 3‐26
ip‐addr IPaddress,indotteddecimalnotation.Theaddressmustbeconfiguredon
oneoftheRoamAboutswitch’sVLANs.