Specifications

RoamAbout Mobility System Software Command Line Reference 7-59
set snmp trap receiver
ThiscommandisdeprecatedinMSSVersion4.0. ToconfigureanSNMPnotificationtarget(also
calledtrapreceiver),seesetsnmpnotifytarget onpage 7‐46.
AddsanIPaddresstotheSNMPtrapreceivertable.
Syntax
set snmp trap receiver ip-addr
Parameters
Defaults
None.
Mode
Enabled.
Example
TosettheIPaddressoftheSNMPtrapreceiverto192.168.0.1,typethefollowingcommand:
RBT-8100# set snmp trap receiver 192.168.0.1
success: change accepted.
Related Commands
• clearsnmptrapreceiveronpage 7‐15
• setipsnmpserveronpage 7 ‐36
• setsnmpcommunityonpage 7‐44
• setsnmptraponpage 7‐58
• showsnmpconfigurationonpage 7‐87
ip‐addr IPaddressofthetrapreceiver,indotteddecimalnotation.