Specifications

7-58 IP Services Commands
set snmp trap
ThiscommandisdeprecatedinMSSVersion4.0. ToenableordisableSNMPnotifications,
configureanotificationprofile.Seesetsnmpprofileonpage 7‐51.
EnablesordisablestheSNMPtrapcapability. Trapsareeventnotifications.Whenatrapcondition
occurs,theRoamAboutswitchsendsanSNMPtrapmessagetoany
networkmanagementsystem
specifiedasatrapreceiver.
Syntax
set snmp trap {enable | disable} [trap-name | all]
Parameters
Defaults
Alltrapsaredisabledbydefault.
Mode
Enabled.
Usage
Youcanenableordisablethelinkupandlinkdowntrapsonanindividualportbasiswiththeset
porttrapcommand.Theindividualportsettingoverridestheglobalsetting.
Examples
Thefollowingcommanddisablesalltraps:
RBT-8100# set snmp trap disable all
success: change accepted.
Thefollowingcommandreenablesauthenticationtraps:
RBT-8100# set snmp trap enable AuthenTraps
success: change accepted.
Related Commands
• clearsnmptrapreceiveronpage 7‐15
• setipsnmpserveronpage 7 ‐36
• setsnmpcommunityonpage 7‐44
• setsnmptrapreceiveronpage 7‐59
• showsnmpconfigurationonpage 7‐87
enable Enablestrapinformationtobesent.
disable Disablesthesendingoftrapinformation.
trap‐name Nameofthetrap:
all
Enablesordisablesalltraps.