Specifications

7-56 IP Services Commands
set snmp protocol
EnablesanSNMPprotocol.MSSsupportsSNMPv1,SNMPv2c,andSNMPv3.
Syntax
set snmp protocol {v1 | v2c | usm | all} {enable | disable}
Parameters
Defaults
AllSNMPversionsaredisabledbydefault.
Mode
Enabled.
Usage
SNMPrequirestheswitch’ssystemIPaddresstobeset.SNMPwillnotworkwithoutthesystem
IPaddress.
YoualsomustenabletheSNMPserviceusingthesetipsnmpservercommand.
Example
ThefollowingcommandenablesallSNMPversions:
RBT-8100# set snmp protocol all enable
success: change accepted.
Related Commands
• setipsnmpserveronpage 7 ‐36
• setsnmpcommunityonpage 7‐44
• setsnmpnotifytargetonpage 7‐46
• setsnmpprofileonpage 7‐51
• setsnmpsecurityonpage 7‐57
• setsnmpusmonpage 7 ‐60
• showsnmpstatusonpage 7‐93
v1 SNMPv1
v2c SNMPv2c
usm SNMPv3(withtheuser
securitymodel)
all EnablesallsupportedversionsofSNMP.
enable Enablesthespecified SNMPversion(s).
disable DisablesthespecifiedSNMPversion(s).