Specifications

7-48 IP Services Commands

SNMPv2c with Informs

Toconfigureanotificationtargetfor informsfromSNMPv2c,usethefollowingcommand:

Syntax

set snmp notify target target-num ip-addr[:udp-port-number] v2c community-string

inform [profile profile-name] [retries num][timeout num]

Parameters

SNMPv2c with Traps

Toconfigureanotificationtargetfor trapsfromSNMPv2c,usethe f ollowingcommand:

Syntax

set snmp notify target target-num ip-addr[:udp-port-number] v2c community-string

trap [profile profile-name]

Parameters

target‐num IDforthetarget.ThisIDislocaltotheRoamAboutswitchanddoes

notneedtocorrespondtoavalueonthetargetitself.Youcanspecify

anumberfrom1to10.

ip‐addr[:udp‐port‐number]IPaddressoftheserver.Youalsocanspecifythe UDP

portnumberto

sendnotificationsto.

community‐string Communitystring.

profileprofile‐name Notificati onprofilethisSNMPuserwillusetospecifythenotification

typestosendordrop.

retriesnum Specifies thenumberoftimesthe MSSSNMPenginewillresenda

notificationthathasnotbeenacknowledgedbythetarget.You

can

specifyfrom0to3retries.

timeoutnum SpecifiesthenumberofsecondsMSSwaitsforacknowledgementofa

notification.Youcanspecifyfrom1to5seconds.