Specifications

7-42 IP Services Commands
set ntp server
ConfiguresaRoamAboutswitchtouseanNTPserver.
Syntax
set ntp server ip-addr
Parameters
Defaults
None.
Mode
Enabled.
Usage
YoucanconfigureuptothreeNTPservers.MSSqueriesalltheserversandselectsthebest
responsebasedonthemethoddescribedinRFC1305,NetworkTimeProtocol(Version3)
Specification,ImplementationandAnalysis.
TouseNTP,youalsomustenabletheNTPclientwiththesetntpcommand.
Example
ThefollowingcommandconfiguresaRoamAboutswitchtouseNTPserver192.168.1.5:
RBT-8100# set ntp server 192.168.1.5
Related Commands
• clearntpserveronpage 7‐10
• clearntpupdate‐intervalonpage 7 ‐11
• setntponpage 7‐41
• setntpupdate‐intervalonpage 7‐43
• showntponpage 7‐85
ip‐addr IPaddressoftheNTPserver,indotteddecimalnotation.