Specifications

RoamAbout Mobility System Software Command Line Reference 7-39
set ip telnet
ChangestheTCPportnumberonwhichaRoamAboutswitchlistensforTelnetmanagement
traffic.
Syntax
set ip telnet port-num
Parameters
Defaults
ThedefaultTelnetportnumberis23.
Mode
Enabled.
Example
ThefollowingcommandchangestheTelnetportnumberonaRoamAboutswitchto5000:
RBT-8100# set ip telnet 5000
success: change accepted.
Related Commands
• cleariptelnetonpage 7‐9
• setiphttpsserveronpage 7‐33
• setiptelnetserveronpage 7‐40
• showiphttpsonpage 7‐80
• showiptelnetonpage 7‐84
Caution: If you change the Telnet port number from a Telnet session, MSS immediately ends the
session. To open a new management session, you must Telnet to the switch with the new Telnet
port number.
port‐num TCPportnumber.