Specifications

RoamAbout Mobility System Software Command Line Reference 7-23
set arp agingtime
ChangestheagingtimeoutfordynamicARPentries.
Syntax
set arp agingtime seconds
Parameters
Defaults
Thedefaultagingtimeoutis1200seconds.
Mode
Enabled.
Usage
Agingappliesonlytodynamicentries.
ToresettheARPagingtimeouttoitsdefaultvalue,usethesetarpagingtime1200command.
Example
ThefollowingcommandchangestheARPagingtimeoutto1800 seconds:
RBT-8100# set arp agingtime 1800
success: set arp aging time to 1800 seconds
ThefollowingcommanddisablesARPaging:
RBT-8100# set arp agingtime 0
success: set arp aging time to 0 seconds
Related Commands
• setarponpage 7‐22
• showarponpage 7‐68
seconds NumberofsecondsanentrycanremainunusedbeforeMSSremovestheentry.You
canspecifyfrom0through1,000,000.Todisableaging,specify0.