Specifications

RoamAbout Mobility System Software Command Line Reference 7-15
clear snmp trap receiver
ThiscommandisdeprecatedinMSSVersion4.0.ToclearanSNMPnotificationtarget(alsocalled
trapreceiver),seeclearsnmpnotifytargetonpage 7‐13.
Syntax
clear snmp trap receiver ip-addr
Parameters
Defaults
None.
Mode
Enabled.
Example
TodeletethetrapreceiveratIPaddress192.168.0.1,typethefollowingcommand:
RBT-8100# clear snmp trap receiver 192.168.0.1
success: change accepted.
Related Commands
• setipsnmpserveronpage 7 ‐36
• setsnmpcommunityonpage 7‐44
• setsnmptraponpage 7‐58
• setsnmptrapreceiveronpage 7‐59
ip‐addr IPaddressofthetrapreceiver,indotteddecimalnotation.