Specifications

6-4 QoS Commands
set qos dscp-to-cos-map
ChangestheinternalQoSvaluetowhichMSSmapsapacket’sDSCPvaluewhenclassifying
inboundpackets.
Syntax
set qos dscp-to-cos-map dscp-range cos level
Parameters
Defaults
Thedefaultsarelistedbytheshowqoscommand.
Mode
Enabled.
Example
ThefollowingcommandmapsDSCPvalues40‐56tointernalCoSvalue6:
RBT-8100# set qos dscp-to-cos-map 40-56 cos 6
warning: cos 5 is marked with dscp 63 which will be classified as cos 7
warning: cos 7 is marked with dscp 56 which will be classified as cos 6
Asshowninthisexample,ifthechangeresultsinachangetoCoS,MSSdisplaysawarning
messageindicatingthechange.
Related Commands
• setqoscos‐to‐dscp‐maponpage 6‐3
• showqosonpage 6‐5
dscp‐range DSCPrange.Youcanspecifythevaluesasdecimalnumbers.Validdecimal
valuesare0to63.
Tospecifyarange,usethefollowingformat:40‐56.Specifythelower
numberfirst.
coslevel InternalQoSvalue.
Youcanspecifyanumberfrom0to7.