Specifications

RoamAbout Mobility System Software Command Line Reference 5-23
show tunnel
DisplaysthetunnelsfromtheRoamAboutswitchwhereyoutypethecommand.
Syntax
show tunnel
Parameters
None.
Defaults
None.
Mode
Enabled.
Example
TodisplayalltunnelsfromaRoamAboutswitchtootherswitchesintheMobilityDomain,type
thefollowingcommand.
RBT-8100# show tunnel
VLAN Local Address Remote Address State Port LVID RVID
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng 192.168.14.2 192.168.14.4 DORMANT 1024 4096 130
Table 5‐5describesthefieldsinthedisplay.
Related Commands
showvlanconfigonpage 5‐24
Table 5-5 Output for show tunnel
Output What It Displays...
VLAN VLAN name.
Local Address IP address of the local end of the tunnel. This is the system IP address of the
RoamAbout switch where you enter the command.
Remote Address IP address of the remote end of the tunnel. This is the system IP address of
another RoamAbout switch in the Mobility Domain.
State Tunnel state:
Up
Dormant
Port Tunnel port ID.
LVID Local VLAN ID.
RVID Remote VLAN ID.