User`s guide

Viewing Network and Device Status
2-12
Viewing Network and Device Status
The Status page displays the connection status for the WAN, WLAN, and LAN interfaces.
It also displays the firmware and hardware version numbers, illegal attempts to access your
network, as well as all DHCP clients connected to your network.
The following information is displayed on the page:
Using Tools
Use the Tools page to reboot, restore to factory defaults, and upgrade the firmware.
You can also reset the RoamAbout R1 back to its original factory by pressing the Reset
button on the back panel for 5 seconds.
Field Description
INERNET Displays connection type and status
.
ROAMABOUT R1 Displays system IP settings, the status for DHCP, NAT and
Firewall services, as well as the wireless interface settings.
INFORMATION Displays the number of attached clients, the firmware versions,
the physical MAC address for each media interface, as well as the
hardware version and serial number.
Security Log Displays any illegal attempts to access your network.
DHCP Client Log Displays information on all DHCP clients on your network.
Field Description
Reset RoamAbout R1 Reboots the RoamAbout R1 and retains the current SAVED
configuration settings.
Restore Factory
Defaults
Removes all configuration settings and restores the
RoamAbout R1 back to its original factory state.
Update Firmware Allows you to check the Enterasys Networks Wireless Web
site for upgrades and upgrade the RoamAbout R1 with the
new firmware.