Specifications

5-11
Configuring APs in a Point-to-Point Network
Using the Access Point 2000 Console Port
1. Choose Set IP Address from the Installation Menu.
2. Enter the IP address, subnet mask, and default gateway.
3. Choose Module-Specific Options from the Installation Menu.
4. Choose Set Wireless Configuration. Enter the parameters for your wireless network.
5. Choose Bridge Mode Options in the Module-Specific Options menu. Set the
parameters as described in Table 5-2.
6. To implement your changes, choose Reset with Current Settings from the
Installation Menu. Allow approximately one minute for the AP to reset and complete
its self-test.
7. Perform this procedure on the other AP.