Specifications

Configuring APs in a Point-to-Point Network
5-10
Using the RoamAbout R2 Console Port or Telnet Connection
1. Choose Network Configuration from the Main Menu.
2. Enter the parameters as described in Table 5-2.
3. Choose Save.
4. Choose Wireless Configuration from the Main Menu, then choose Set/Show
Wireless Configuration.
5. At the top of screen, choose the radio slot (1 or 2) to configure.
6. Enter the wireless parameters.
7. Set the Reset Option to Reset Radio if necessary (default setting).
8. Choose Save.
9. If changing the bridge mode, you need to implement your changes by choosing
Reset/Upgrade in the Main Menu then choosing Reset Switch. Allow approximately
one minute for the AP to reset and complete its self-test.
10. Perform this procedure on the other AP.
Using the RoamAbout R2 Web Interface
1. Open Network Configuration in the navigation tree.
2. Select Network Parameters in the navigation tree. Enter the parameters as described
in Table 5-2.
3. Click on Save.
4. Select Identification in the navigation tree. Enter the identification information.
5. Click on Save.
6. Open Wireless Parameters in the navigation tree.
7. Select the slot to configure. Enter the parameters as described in Table 5-2.
8. Click on Save.
9. To implement your changes, select Reset under Reload/Reset. If changing the bridge
mode, select Reset with Current Settings. Otherwise, select Reset Slot x, where x is
the slot (1 or 2) you configured. Allow approximately one minute for the AP to reset
and complete its self-test.
10. Perform this procedure on the other AP.