Specifications

Configuring APs in an Infrastructure Network
5-6
Using the Access Point 2000 Console Port
1. Choose Set IP Address from the Installation Menu. Enter the parameters as described
in Table 5-1.
2. Choose Module-Specific Options from the Installation Menu.
3. Choose Set Wireless Configuration. Enter the wireless parameters for your wireless
network as described in Table 5-1.
4. Choose Module-Specific Options from the Installation Menu and set the bridge mode
and rate limiting parameters as described in Table 5-1.
5. To implement your changes, choose Reset with Current Settings from the
Installation Menu. Allow approximately one minute for the AP to reset and complete
its self-test.
To configure the RoamAbout wireless clients, write down the Wireless network name
especially if Secure Access is enabled.