Specifications

Configuring the AP for Authentication
6-14
Using the RoamAbout R2 Web Interface
1. Open Authentication in the navigation tree.
2. Select Slot 1 or Slot 2.
3. Select the authentication mode: MAC, 802.1X, or Hybrid. The None option disables
authentication.
4. If you selected 802.1X or Hybrid authentication, enter the 802.1X parameters.
5. Optionally, if you selected 802.1X or Hybrid authentication, enable Rapid Rekeying
and enter its parameters. These parameters are described in Configuring for Rapid
Rekeying on page 6-18.
6. Click Save.
7. Open RADIUS in the navigation tree.
8. Select RADIUS in the navigation tree.
9. Enable RADIUS authentication.
10. Enter the RADIUS server parameters.
11. Click Save.
12. If you enabled MAC, 802.1X, or Hybrid authentication, perform the following to
implement your changes. If only changing RADIUS or 802.1X parameters, a reset is
not needed.
a) Select Reload/Reset in the navigation tree.
b) Select Reset.
c) Click on Reset Slot x, where x is the slot (1 or 2) you configured. Allow
approximately one minute for the AP to reset and complete its self-test.