Specifications

6-13
Configuring the AP for Authentication
5. If you enabled MAC or 802.1X authentication, perform the following to implement
your changes. If only changing RADIUS or 802.1X parameters, a reset is not needed.
R2 AP: Select Reset from the main window. Select Reset Slot x, where x is the slot
(1 or 2) you configured.
AP 2000: If prompted, reset the AP. Otherwise, select Reset from the main window.
Select Reset with Current Settings.
Allow approximately one minute for the AP to reset and complete its self-test.
Using the RoamAbout R2 Console Port or Telnet
1. Choose Security and Policy Configuration from the Main Menu.
2. Choose RADIUS Client Configuration.
RADIUS: Enable. The RADIUS Client Parameters screen displays.
3. Enter the RADIUS client information.
4. Choose Save.
5. Choose Authentication Configuration from the Security and Policy Configuration
menu.
Authentication Configuration Slot: 1 or 2
Authentication Mode: Choose MAC, 802.1X, or Hybrid (MAC and 802.1X).
6. If 802.1X or hybrid was chosen, enter the 802.1X parameters. Optionally, configure
Rapid Rekeying. See Configuring RADIUS Accounting on page 6-16.
7. Choose Save.
8. If you enabled MAC or 802.1X authentication, perform the following to implement
your changes. If only changing RADIUS or 802.1X parameters, a reset is not needed.
a) Choose Reset/Upgrade from the Main Menu.
b) Choose Reset Radio.
Slot: Choose Radio 1 or Radio 2.
Reset Option: Set to Reset Radio Regardless.
c) Choose Apply.
To view the RADIUS client statistics, see Monitoring RADIUS Client Operations on
page 7-11.