Specifications

Setting Secure Access
6-4
Setting Secure Access
Secure Access only applies in a wireless infrastructure network. This parameter is only
available at the AP. When Secure Access is enabled, the AP denies access to wireless
clients that do not use the correct wireless network name. When Secure Access is disabled,
the AP allows access to wireless clients that use ANY (all uppercase) as the wireless
network name or have a blank wireless network name.
Perform one of the following to view or change the Secure Access setting.
• Using the AP Manager, click on the Wireless Parameters button then click on the
Advanced button. Use the Help button for detailed information. A reset is not needed.
• Using the RoamAbout R2 console port or Telnet, choose Wireless Configuration
from the Main Menu then choose Set/Show Wireless Configuration. A reset is not
needed.
• Using the RoamAbout R2 web interface, open Wireless Parameters in the navigation
tree and select Slot 1 or Slot 2. A reset is not needed.
• Using the Access Point 2000 console port, choose Module-Specific Options from the
RoamAbout AP Installation Menu then choose Set Wireless Configuration. A reset
is not needed.