Specifications

5-35
Configuring Clients
• Hardware Reload/Reset button
— RoamAbout R2. The R2 has a reload/reset button that is only used to download
a new image from a TFTP server, as described in Using the AP Hardware Reset
Button on page 7-18. When downloading a new image, the R2 automatically
resets to the factory default values.
— AP 2000. The AP’s reload/reset button forces the AP to download a new firmware
image from a BootP/TFTP server and reset to factory default values. If a new
image is not available, the AP resets to factory default values after approximately
three minutes. Make sure that you do not have multiple BootP/TFTP servers
configured to load the AP; you might load an incorrect image. Allow
approximately one minute for the AP to reset and complete its self-test.
Configuring Clients
To configure the clients, refer to the RoamAbout 802.11 PC Card Drivers and Utilities
Setup and Installation Guide and the client online help.
Check the
enterasys.com/wireless web site frequently for client upgrades and
documentation revisions.