Specifications

Resetting the RoamAbout AP
5-34
Resetting the RoamAbout AP
This section describes how to reset the AP.
• Reset with Current Settings
If you change any wireless configuration parameter, such as the wireless network name
or channel, you must select this option to reset the AP to implement your changes.
Allow approximately one minute for the AP to reset and complete its self-test.
— From the AP Manager, select Reset then select Reset with Current Settings.
— From the R2 console port or Telnet session, select Reset/Upgrade from the Main
Menu and then select Reset Switch.
— From the R2 web interface, open Reload / Reset in the navigation tree and select
Reset. Select Reset with Current Settings and click on Save.
— From a device attached to the Access Point 2000 console port, select Reset with
Current Settings from the RoamAbout AP Installation Menu.
• Reset Card (RoamAbout R2 only)
If you change any wireless configuration parameter that affects only one wireless card
(slot 1 or 2), select this option to only reset the affected wireless card and implement
your changes.
• Reset with Factory Defaults
This option reboots the AP, deleting all configuration settings and replacing them with
factory default values. All configuration settings are lost, including the IP address.
— From the AP Manager, select the AP from the Managed List field, click on the
Reset button, then click on the Reset with Factory Defaults button.
— From the R2 console port or Telnet session, select Reset/Upgrade from the Main
Menu, then select Reset Switch with Factory Defaults.
— From the R2 web interface, open Reload / Reset in the navigation tree and select
Reset. Select Reset with Factory Defaults and click on Save.
— From a device attached to the Access Point 2000 console port, select Reset with
Factory Defaults from the RoamAbout AP Installation Menu.