Specifications

Setting Spanning Tree
5-28
Using the Access Point 2000 Console Port
You can enable or disable the Spanning Tree when in endpoint bridge mode. Spanning Tree
is disabled when in workgroup bridge mode and enabled in multipoint bridge mode. To
enable or disable Spanning Tree using the console port, perform the following:
1. Choose Module-Specific Options from the RoamAbout AP Installation Menu.
2. Choose Bridge Mode Options.
3. Choose Set Spanning Tree Mode and set to Enabled or Disabled.
4. To implement your changes, reset the AP by choosing Reset with Current Settings
from the Installation Menu. Allow approximately one minute for the AP to reset and
complete its self-test.