Specifications

Configuring for VLANs
5-26
To enable or disable GVRP (RoamAbout R2 only):
1. Click on the VLAN Parameters button.
2. Enable or disable GVRP.
3. Click on OK.
To enable or disable VLAN compatibility on the AP 2000:
1. Click on the VLAN Parameters button.
2. Enable or disable Allow Tagged Packets.
3. Click on OK.
Using the RoamAbout R2 Web Interface
To access the VLAN configuration pages, click on VLANs/Multicast Groups in the
navigation tree.
Using the RoamAbout R2 Console Port or Telnet
The R2 console port/Telnet interface does not support configuring VLANs. However, you
can enable or disable GVRP as follows. A reset is not needed to implement VLAN changes.
1. Choose Network Configuration from the Main Menu.
2. Enable or disable GVRP.
3. Choose Save.
Using the Access Point 2000 Console Port
A reset is not needed to implement VLAN changes.
1. Choose Module-Specific Options from the Installation Menu.
2. Choose VLAN Options.
Set VLAN Compatibility Mode: Enable to forward VLAN data. Disable to not
forward VLAN data.
3. Choose Save.