Specifications

Modifying the IP Address
5-20
Using the RoamAbout R2 Web Interface
1. Open Network Configuration in the navigation tree.
2. Select Network Parameters and enter the following parameters:
IP address: If manually entering an IP address, enter the IP address you wish to assign
to the AP.
Subnet mask: Enter the subnet mask you wish to assign to the AP.
Default gateway: Enter the IP address of the default gateway.
IP Address Initialization: Choose the method to obtain an IP address on the next
reset.
3. Click on Save. You do not need to reset the AP.
Using the Access Point 2000 Console Port
To manually enter an IP address, and disable both BOOTP and DHCP, go to Set IP
Address in the Main Menu and enter an IP address. A reset to the AP is not needed.
To change how the IP address is obtained, perform the following:
1. Choose Module-Specific Options from the Main Menu.
2. Choose Choose BOOTP or DHCP to get IP Address.
3. Enable DHCP or BOOTP. The AP obtains an IP address on the next reset.
To modify only the subnet mask or default gateway, go to Set IP Address in the Main
Menu.
NOTE: If the AP has an IP address and you wish to enable DHCP or
BOOTP, you must first go to Set IP Address and set the IP address to
0.0.0.0.