Specifications

5-19
Modifying the IP Address
To manually change the IP address of an Access Point 2000, perform the following. You
will need the AP’s wired MAC address and an unused IP address.
1. Select the AP in the managed list.
2. Click on the Network Parameters button.
3. Set the Address State to Volatile.
4. Select Manual from the IP Address Initialization option.
5. Click on OK.
6. In the main AP Manager window, click on the Reset button. Then, click on Reset with
Current Settings.
7. Click on the Setup/Add New AP button from the main window.
8. Click on Yes in the Load IP Address message.
9. In the Load IP Address dialog, enter the wired MAC address, new IP address, and other
parameters as necessary.
10. Click on OK.
11. If a message displays about reloading an R2, click on OK to close the message and
continue loading the new address.
Using the RoamAbout R2 Console Port or Telnet
1. Choose Network Configuration from the Main Menu and enter the following
parameters:
IP address: If manually entering an IP address, enter the IP address you wish to assign
to the AP.
Subnet mask: Enter the subnet mask you wish to assign to the AP.
Default gateway: Enter the IP address of the default gateway.
IP Address Mode: Choose the method to obtain an IP address on the next reset.
2. Choose Save. You do not need to reset the AP.