Specifications

Configuring the AP for Point-to-Multipoint
5-16
6. Open Wireless Parameters in the navigation tree.
7. Select the slot to configure. Enter the parameters as described in Table 5-3.
When configuring the bridge mode of the Central AP to LAN-to-LAN Multipoint,
you must enter the Multipoint activation key. This option is only available on slot 1.
Click on the LAN-to-LAN Properties button to enter the wireless MAC addresses of
the other APs. Any unused fields must be null (contain no characters).
8. Click on Save.
9. To implement your changes, select Reset under Reload/Reset. If changing the bridge
mode, select Reset with Current Settings. Otherwise, select Reset Slot x, where x is
the slot (1 or 2) you configured. Allow approximately one minute for the AP to reset
and complete its self-test.
10. Perform this procedure on the other AP.
Using the Access Point 2000 Console Port
1. Choose Set IP Address from the Installation Menu.
2. Enter the IP address, subnet mask, and default gateway.
3. Choose Module-Specific Options from the Installation Menu.
4. Choose Set Wireless Configuration. Enter the wireless parameters for your wireless
network as described in Table 5-3.
5. Choose Bridge Mode Options from the Module-Specific Options menu and continue
entering the wireless parameters.
When configuring the bridge mode of the Central AP to LAN-to-LAN Multipoint,
you must enter the Multipoint activation key. This option is only available on the
Access Point 2000 V6.0 (or later).
6. To implement your changes, reset the AP by choosing Reset with Current Settings
from the Installation Menu. Allow approximately one minute for the AP to reset and
complete its self-test.
7. Repeat this procedure at the other APs.