Specifications

5-15
Configuring the AP for Point-to-Multipoint
9. To implement your changes:
R2 AP: Select Reset from the main window. If changing the bridge mode, select Reset
with Current Settings. Otherwise, select Reset Slot x, where x is the slot (1 or 2) you
configured.
AP 2000: Select Reset from the main window. Select Reset with Current Settings.
Allow approximately one minute for the AP to reset and complete its self-test.
10. Repeat this procedure at the other APs.
Using the RoamAbout R2 Console Port or Telnet Connection
1. Choose Network Configuration from the Main Menu.
2. Enter the parameters as described in Table 5-3.
3. Choose Save.
4. Choose Wireless Configuration from the Main Menu, then choose Set/Show
Wireless Configuration.
5. At the top of screen, choose the radio slot (1 or 2) to configure.
6. Enter the wireless parameters.
When configuring the bridge mode of the Central AP to LAN-to-LAN Multipoint,
you must enter the Multipoint activation key. This option is only available on slot 1.
7. Set the Reset Option to Reset Radio if necessary (default setting).
8. Choose Save.
9. If changing the bridge mode, you need to implement your changes by choosing
Reset/Upgrade in the Main Menu then choosing Reset Switch. Allow approximately
one minute for the AP to reset and complete its self-test.
10. Repeat this procedure at the other APs.
Using the RoamAbout R2 Web Interface
1. Open Network Configuration in the navigation tree.
2. Select Network Parameters in the navigation tree. Enter the parameters as described
in Table 5-3.
3. Click on Save.
4. Select Identification in the navigation tree. Enter the identification information.
5. Click on Save.