Installation guide

Mounting the Antenna
RoamAbout Antenna Site Preparation and Installation Guide 3-33
Tomountthe802.11a/b/grangeextenderomni‐directionalantennafromaceiling,performthe
followingsteps:
1. Surveytheareaforthebestlocationfortheantenna.
2. Runthecablefromtheaccesspointtothedesiredlocation.
3. Drilla3/4‐inch(2cm)holethroughtheceilingsurfaceatthedesiredlocation.
(Maximum
ceilingthickness:3/4‐inch(2cm)
4. Inserttheantennacablingintotheceiling.Replacetheceilingtile,ifnecessary.
5. Pushthethreadedpartoftheantennathroughthehole.
6. Passthecablethroughthewasherandthenut,andtightenthenutmoderatelyontheopposite
sideoftheceiling.
7. Attachthecable
totheantennaconnector.
8. Aftermountingtheantenna,connecttheantennacablesasdescribedin“Connectingthe
AntennaCables”onpage 3‐34.