Installation guide

Mounting the Antenna

RoamAbout Antenna Site Preparation and Installation Guide 3-21

8. Aftermountingtheantenna,connecttheantennacablesasdescribedin“Connectingthe

AntennaCables”onpage 3‐34.

Mounting On a Wall

Figure 3‐10illustrateshowtomounttheRoamAbout5.3and5.8GHzomni‐directionalantennas

onawall.Table 3‐9liststhewallmountingcomponents.

Figure 3-10 Wall Mounting the 5.3 and 5.8 GHz Omni-Directional Antenna

Tomounta5.3or5.8GHzomni‐directionalantennatoawall,performthefollowingsteps:

1. Inserttheconnectorendoftheantennathroughthe

largeholeinthemountingbracket.

2. Insertthewasherovertheantennaconnectorend.

3. Threadthenutovertheantennaconnectorenduntilthenutisfingertight.

4. Tightenthehexnutwithawrench.

Note: Do not allow the top surface of the bracket to exceed the top of the mast.

Table 3-9 5.3 and 5.8 GHz Omni-Directional Antenna Wall Mounting Components

# Component

1 Antenna (RBTES-AH-M10M) or (RBTES-AM-M10M)

2 Mounting bracket

3 Lock washer and hex nut for securing antenna to mount

4 Screws for fastening bracket to wall

Note: The antenna kit does not include the screws required to fasten the bracket to wall.