Installation guide

Mounting the Antenna

3-20 Antenna Installation

Mounting On a Mast

Figure 3‐9illustrateshowtomounttheRoamAbout5.3and5.8GHzomni‐directionalantennason

amast.Table 3‐8liststhemastmountingcomponents.

Figure 3-9 Mast Mounting the 5.3 and 5.8 GHzOmni-Directional Antenna

Tomounta5.3or5.8GHzomni‐directionalantennatoamast,performthefollowingsteps:

1. Inserttheconnectorendoftheantennathrough

thelargeholeinthemountingbracket.

2. Insertthewasherovertheantennaconnectorend.

3. Threadthenutovertheantennaconnectorenduntilthenutisfingertight.

4. Tightenthehexnutwithawrench.

5. Placeeachoftheclampsintoeachofthenotchesonthesidesofthebracket.

6. Place

clampsoverthetopofthemast.

7. Aligntopofbracketwithtopofmastandtightenclampstosecurebrackettomast.

Table 3-8 5.3 and 5.8 GHz Omni-Directional Antenna Mast Mounting Components

# Component

1 Antenna (RBTES-AH-M10M) or (RBTES-AM-M10M)

2 Mounting bracket

3 Lock washer and hex nut for securing antenna to mount

4 Clamps

5 Mast (user supplied)