Installation guide

Mounting the Antenna
RoamAbout Antenna Site Preparation and Installation Guide 3-13
TomounttheRoamAbout2.4GHzdirectionalantennatoanarrowmast,performthef ollowing
steps:
1. Removethenuts,flatandchannelwashersfromtheopenendoftheU‐bolt.
2. RemovethebracketnearesttotheopenendoftheU‐bolt.
3. InserttheU‐boltaroundthemast.
4. Reversetheorientation
ofthebracketthatyouremovedsothatitisontheU‐boltinthesa me
orientationastheotherbracket.(Thatis,withtheconvexsideofthebracketfacingtheclosed
endoftheU‐boltandtheconcavesideoftheU‐boltfacingtheopen
endoftheU‐bolt.)
5. Replacethenuts,flatandchannelwashersontheendsoftheU‐bolt.
6. Tightenthenutsuntilthebracketsgripthemastsnugly.
7. Turnthetiltangleadjustertotheangleatwhichyouwanttomounttheantenna.
8. Repeatsteps1through7toattachthe
secondU‐boltmounttothemast.
9. ConnecttheantennatothescrewsinthemiddleofthetiltangleadjustersoneachU‐bolt.
10. Aftermountingtheantenna,connecttheantennacablesasdescribedin“Connectingthe
AntennaCables”onpage 3‐34.
Note: Install the channel washer on the notched side of the bracket.